SYSTEM PROGRAMMING -
Menu 1
INSTALL MANUAL
DIAGNOSTICS
AL.1
ALARM STATUS / DIAGNOSTICS
ALARM STATUS / DIAGNOSTICS
LED FLASHES
OUTPUT DIAGNOSTICS
2
LOCK OUTPUT OVERLOAD
3
UNLOCK OUTPUT OVERLOAD
4
TRUNK OUTPUT OVERLOAD
5
STARTER DISABLE OVERLOAD
6
NOT USED
7
AUX 5 OUTPUT OVERLOAD
8
2ND UNLOCK OUTPUT OVERLOAD
If the alarm system is triggered, the system will retain in memory the cause of the
trigger. When disarming the alarm, the siren will chirp 3 times to indicate the alarm
had been triggered. The system’s LED will also flash in pulses to indicate which input
triggered the alarm.
*LED status will be cleared when the ignition is turned ON. For proper memory
clearing, insure to connect the alarm ignition input to the ignition on the vehicle.
If an output from the alarm is shorted the siren
will
chirp
4
times
and
the
park
lights
will
flash
4
times when the system is armed or disarmed. The LED
will
flash a
diagnostic code that represents the circuit that is at fault. (See Chart Below). Turning
the ignition to the on then off position will reset the diagnostic code.
SIREN CHIRPS
LED FLASHES
DIAGNOSTICS / STATUS
3
2
SHOCK SENSOR TRIGGER
3
3
DOOR / HOOD TRIGGER
3
4
IGNITION TRIGGER
0
OFF
SYSTEM DISARMED
0
ON SOLID
SYSTEM IN VALET / SERVICE MODE
0
SINGLE FLASHES
SYSTEM ARMED
0
RAPID FLASHES
PASSIVE ARM COUNTDOWN
CAR SECURITY SYSTEM
SOUNDSTREAM CAR ALARMS
