RCD1770 / English Instruction Manual
2
GETTING STARTED
DAB/FM AERIAL
Before using your radio for DAB or FM reception, pull out the telescopic antenna. You may need
to adjust the position of the telescopic antenna for maxing signal strength.
CONNECTING POWER
Before connecting the power, check that the mains voltage on the rating plate which is same as
the voltage in your area.
Plug the AC cord into the AC socket at the back of the unit.
Plug the VDE plug into the wall socket.
Press the
“STANDBY” button then press “SOURCE” to select function. The unit is now
ready for use.
NOTE:
When first connected to
the power, the clock display will show “zeros” and blinks.
BATTERY OPERATION
Disconnect the AC cord Set completely. Open the Battery Compartment door and insert
6 pieces LR14 / UM-2 "C" size batteries into the battery compartment with battery polarity as
shown inside the battery compartment.
SETTING THE CLOCK
The clock on your radio is automatically set when first used from the time signal broadcast with
DAB radio stations.
If a DAB station is not available, the clock may be set manually via the menu system. (Please
refer to SET CLOCK page).
STANDBY CONTROL
To turn the unit on:
Press the
“STANDBY” button.
The display will light and the unit will switch on.
To turn the unit in standby mode:
Press the
“STANDBY” button.
This unit will switch off. The clock will continue to run whilst mains power is connected.
ENERGY SAVING/ ERP2 REGULATION
This device is equipped with an automatic switch off / STANDBY system for energy-saving
requirements. This is regulated by an EU-standard and is NOT A MALFUNCTION.
