SoundCraft MBI 10 Series, Руководство пользователя

Страница: 19 / 54

Mono Input Channel
REMOTES SOCKET (25-pin D-type female)
This socket provides for the following facilities:
Input 1 Cue Lamp
A relay switch closes between pins 12 & 13 of the Remotes socket when the
following conditions are all met:
The Mic input is selected, the REM button is depressed and the Fader is up.
The following diagram shows one possible method of using this relay switch to
control a cue lamp. It is vital that mains voltages are NOT connected to any of the
connectors on the console.
Console
Opto-isolated
Solid-state
Relay
Cue-Lamp
N
L
E
Mains
20
+16V
13
12
18
Remotes Skt
Current limiting
resistor
Input 2 Start
A relay switch closes between pins 8 & 9 of the Remotes socket when the following
conditions are all met:
The LINE input is selected, the REM button is depressed
and the Fader is up.
Note: The relay may be configured to pick momentarily or latch depending upon
link 6: if link 6 is present it causes the relay to latch.
Input 2 Stop/Re-Cue
A relay switch closes momentarily between pins 6 & 7 of the Remotes socket when
the following conditions are all met:
The LINE input is selected, the REM button is released
and the Fader is down.
Talkback
Two pins on the Remotes socket are used for this feature, as follows:
Ground Pin 3
Talkback enable Pin 15
A switch may be connected between pins 15 & 3. When this switch is closed the
pre-fade input signal is fed to the T/B MIX bus. This would, for example, let a
Studio Guest talk off-air to a telephone Caller provided that the Talkback feature
on the Telco channel is also used.
Applications 13