sound4 SOUND4 BIG VOICE2 Base, Инструкция по эксплуатации

Страница: 84 / 97

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel.: +359 56 710710, Fax: +359 56 836700
Email: sales@sound4.com, Web: www.sound4.com
- 84 -
original input signal (even if the audio is heavily processed) by proportionally modifying the
processing thresholds in the background to reach the percentage set within parameter. A visible
indication of this action will not be evident but it will make a noticeable difference, especially with
aggressive processing settings.
Sound Impact System – The Sound Impact System option makes the sound more impact and
punchy. This is done by dynamically adjusting the timing constants based on the incoming audio
and looking for changes smaller than the ones applied in this setting. The indicator placed in the
middle of the control window will display when SIS is in effect.
Drive – Is used to apply more or less drive to the 3-Band processing section.
Threshold
– Will trim the threshold level where the processing begins to work.
Attack – Is set in dB per second and is intended to control the attack time in the 3-Band
processing section.
Release
– Is set in dB per second and is used to control the release time for the 3-Band processing
section.
Out – Is used to adjust the final output level of the bands.
Post-EQ (Basic)
The second 4-Band Parametric EQ is right after the 3-Band Processing and allows a final fine
tuning to be made so that the desired sound texture could be obtained. It functions identically to
the Pre-EQ section.
Post-EQ (Advanced)
The advanced Post-EQ adds additional controls as follows:
• Frequency – Allows the center frequency of the EQ band to be set.
• Q
– Used to set the bandwidth of the band’s filter. Lower numbers result in a “wider” filter
and higher numbers result in a narrower filter with a sharper “Q”.
• Gain – Adjusts the gain of each band.
Brick Wall Limiter
The final stage of the processing is the Brick Wall Limiter. It takes place right before the output,
and is the only stage in the chain that cannot be entirely bypassed. Although the Drive can be
switched ON and OFF (set to zero) the Brick Wall Limiter will not allow the output of the chain
to exceed 0 dBFS.
Metering – Depicts the amount of gain reduction applied by the final Brick Wall Limiter.
Drive – Is used to trim the amount of drive applied to the Final Brick Wall Limiter.
Release
– Is used to adjust the release time of the final limiter section. By default, the option is
set to Medium Fast.