sorin Intensia DR 154, Руководство по имплантации

Страница: 37 / 66

14. IMPLANT PROCEDURE
Connectors:
The bipolar pacing/sensing connector is compatible with the IS-1 standard and the
quadripolar connector is compatible with the DF-4 standard (refer to the “Lead evaluation
and lead connection” sub-section in the “Warnings and precautions” section).
14.8. SHOCK CONFIGURATION (+ -> -)
The shock configuration is the energy pathway between the defibrillation electrodes. If an
atrial coil is present, the shock configuration can be programmed for bi-directional shocks.
Programming :
When active case and SVC are both programmed to Yes, the shock configuration can be
programmed to:
─ RV to Case (or Case to RV),
─ or RV to SVC (or SVC to RV),
─ or RV to Case+SVC (or Case+SVC to RV).
RV to Case+SVC RV to Case RV to SVC
The polarity of shock is determined by the parameter itself.
14.9. MEASUREMENT OF THRESHOLDS AT IMPLANT
Pacing and sensing thresholds should be measured at implant.
Pacing thresholds:
Acute thresholds should be lower than 1 V (or 2 mA) for a 0.35 ms pulse width, both in the
ventricle and in the atrium.
Sensing thresholds:
For proper ventricular sensing, the amplitude of the R-wave should be greater than 5 mV.
For proper atrial sensing, the amplitude of the P-wave should be greater than 2 mV.
SORIN – INTENSIA DR 154 – U152A 35
NOTE1: Please note that DF-1 standard compliant lead is not compatible with DF-4
connector. In the opposite, DF-4 standard compliant lead is not compatible with DF-1
connector. In case of defibrillator replacement and use of a DF-1 lead or any other lead type
that require an adaptor for this device, please contact your Sorin representative for any
information on lead / connector compatibility question.
NOTE2: In case no atrial lead is implanted, the atrial port should be plugged with IS-1
insulating plug and a single chamber mode (VVI-VVIR) should be programmed. PARAD and
PARAD+ should not be used.