SORG Loop RS, Сервисная книжка

Страница: 25 / 40

Service Record Loop
SORG
RS 25 of 40 2019-07-16
3.5 Assembly Group Leg support
All leg supports are mounted under the seat plate, which is shown transparent here. You have two
scenarios available with which you can adjust the distance of the adapter to the seat shell.
1. Displacing the leg support adapter:
3.5.1 Positioning the leg supports
• (1) If necessary, you must move the
wedge adapter (here displayed transpar-
ent), so that through the mounting holes
(A) the holes underneath (2A) between
adapter (2B) and seat plate are accessi-
ble.
• Remove all four screws (B) and
• move the wedge adapter as stated
above.
• (2) Remove the screwing (A) between
adapter (B) and seat plate on both sides,
• move the adapter (B) along the drilled
holes (C) (= per hole about 2 cm),
• replace the screwing (A) back through
the seat plate and retighten the screws.
• Correct the position of the wedge adapt-
er and
• screw it back on to the seat plate tightly.
2. Displacing the leg support in the adapter:
• (3) Loosen both screws (B) on the leg
support adapter (A) and slide the leg
support bars in the desired position.
• Retighten both screws (B) .
• (4) When it comes to the leg supports
which swing to the side, loosen the
headless screw (A)
• push the leg support bars (B) in the de-
sired position and
• retighten both screws (A) .
• (5) So that the top end of the leg sup-
port bars (A) is stabilized under the foot-
rest, two square tubes (B) are mounted
under the seat plate.
(5) The end of the leg support bar must always
overlap the stabilizing tube at least 1 cm.
After every change on the leg support be
sure to make sure that the casters can free-
ly turn 360° by maximum tilting. If necessary,
make corrections on the casters or on the leg
support.
(1)
(B)
(C)
(C)
(A)
(A)
(A)
(B)
(C) (C)
(2)
(4)
(A)
(B)
min.
10 mm
(A) (B)
(3)