Service Record Loop
SORG
RS
19 of 40
2019-07-16
3.3.2 Vertical displacement of the seat plate
In addition to the ability to define the seat
height by the positioning and size of the drive
and steering wheels, this can also be changed
by vertical displacement of the seat plate.
To change the seat height in 20 mm incre-
ments with the same tilting path:
• (1)
loosen both screws
(C)
of the guide
clamp on both sides and
• remove both screws of the screw con-
nection
(A)
of the seat unit incl. the
calipers
(B)
on both sides completely.
• (2)
Remove the screw connection of the
gas spring
(F)
incl. The sleeves comple-
tely.
• (2)
Move the seat unit with the supports
(D)
to the desired dimension in the hole
pattern
(E)
(± 20 mm / 2 cm per hole),
• (2)
move the gas spring in the hole
pattern
(G)
(± 20 mm / 2 cm per hole)
to the same extent.
• Insert the screws
(1A)
with the calipers
(1B)
into the new position and turn
them tight.
• Insert the screw
(2F)
with the sleeves
into the connection of the gas spring
and turn it tight.
After any change to the seat unit and /
or tipping, the tipping behavior of the Loop-
SORG
RS must be retested and practiced with
the help of an experienced, strong helper.
If you do not move the seat assembly
in parallel with the gas spring, the result is a
different tilt path and a different seat angle.
(1)
(2)
(A)
(C)
(D)
(E)
(B)
(G)
(F)
3.3
Assembly Group Seat
Содержание Loop RS
Страница 4: ...4 of 40 Service Record LoopSORG RS 2019 07 16...
Страница 9: ...Service Record LoopSORG RS 9 of 40 2019 07 16...
Страница 34: ...34 of 40 Service Record LoopSORG RS 2019 07 16...