SOREX
wireless Solutions GmbH
Technologie- und Forschungszentrum
Viktor-Kaplan-Straße 2,B
2700 Wiener Neustadt, Österreich
UID
ATU57865279
PayPal
Bank
Raiffeisenbank Pittental
IBAN
AT223264700000052324
BIC
RLNWATW1647
Wir möchten Ihnen Türen öffnen
T
+43 2622 32013-0
F
-15
@
w³
www.sorex-schliesssystem.com
SOREX electronic handle SMART with keypad
Quick Starting Guide
This quick starting guide will show how to set up the SOREX electronic handle SMART with keypad and how
to configure user cards. More Information can be received on our website www.sorex.eu, or by contacting our
support hotline.
Installing the handle on the door
1.
Attach the door handle to the mounting on the inside and fix it using a hex key (Figure 1).
2.
Install the mounting on the inside of the lock by inserting the spindle into the door.
3.
Connect the cover on the outside to the spindle and lead the wire on the upside through the door
(Figure 2).
Please note: Make sure that the writing saying “TOP” can be seen on the top of the spindle!
4.
Screw the electronic handle on the top and the bottom (Figure 3).
5.
Plug in the wire and insert three AAA-Batteries.
6.
Put on the cover on the inside and loose the screw on the bottom, until the cover cannot be moved.
Adding user cards
1.
Hold the management card near the reader. You will hear two low sounds, followed by two high
sounds.
2.
Within ca. 5 seconds, hold the user card you want to add near the reader. You will hear a high pitched
sound to confirm that the card was successfully added.
Figure 1: Attaching the door handle
Figure 2: Connecting the cover on the outside Figure 3: Screwing the electronic handle
