XAV-AX150
5
Sony CONFIDENTIAL
For Authorized Servicer
CHECKING AND SETTING METHOD OF DESTINATION CODE
When the MAIN board or IC801 on the MAIN board is replaced, the
destination code checking is necessary.
If the correct destination code is not displayed, it is necessary to set
the destination code.
Note 1:
Remote commander is necessary for checking and setting opera-
tion.
1. Checking of Destination Code
After replacing the MAIN board or IC801 on the MAIN board with a
new part, according to procedure below, check the destination code.
Checking procedure:
1. Connect the power cord to the regulated DC power supply, and
turn the power on of this unit.
+
–
Regulated DC
power supply
stand, etc.
2. Touch the [OK] on the “Initial Setting” screen, the screen chang-
es to the “For your safety” screen and then the home screen is
displayed.
Do not watch and operate the unit while driving.
Follow your local traffic laws and regulations.
For your safety:
1:00 AM
Close
Language
Demo
Set Date
/
Time
English
ON
01/01/2018
Initial Setting
1:00 AM
OK
For your safety screen
Touch the [OK]
Initial Setting screen
(Displayed screen in the above
fi
gure are example)
3. Press the [HOME] button on the main unit.
– Lower side of front panel –
Press the [HOME] button
4. Press the [OFF] button on the remote commander to the state of
source off, enter the destination code checking mode by pressing
the buttons on the remote commander in order of the [4]
t
[5]
t
[6] (press only the [6] button for two seconds).
Tuner
AM
Source off (HOME screen)
Rear Camera
Phone
USB
BT Audio
(Displayed screen in the above
fi
gure are example)
5. Check the destination code of 6 digits on the screen display is a
value of “00D442”.
Note 2:
If “00D442” is not displayed or another destination code is dis-
played, proceed to “2. Setting of Destination Code” on page 6.
CPU Version
MCU Version
DSP Version
OSD Version
Destination Code
BD ADDRESS
1242
1243
3730
1806011349
0 0 D 4 4 2
12:34:56:78:90:AB
check
(Displayed characters/values in the above
fi
gure are example)
6. Press the [OFF] button on the remote commander, the unit auto-
matically restarts and return to the “Initial Setting” screen.
Language
Demo
Set Date
/
Time
English
ON
01/01/2018
Initial Setting
1:00 AM
OK
Initial Setting screen
CPU Version
MCU Version
DSP Version
OSD Version
Destination Code
BD ADDRESS
1242
1243
3730
1806011349
0 0 D 4 4 2
12:34:56:78:90:AB
(Displayed screen in the above
fi
gure are example)
7. This completes the destination code checking work.
Note 3:
If the correct destination code is not displayed in step 5, refer to “2.
Setting of Destination Code” on page 6 continuously.
SYS SET
2020/02/07 23:51:10 (GMT+09:00)