![Sony Super HAD CCD SSC-DC132P Скачать руководство пользователя страница 27](http://html.mh-extra.com/html/sony/super-had-ccd-ssc-dc132p/super-had-ccd-ssc-dc132p_service-manual_418350027.webp)
4-9
SSC-DC132P/134/134P/138P
4-4-10. Data Write
1.
Press the commander's STEP FORWARD button
once. The mode indicator will display “63” and the
data indicator will displays “02”.
2.
Press the STEP FORWARD button of the commander
once.
The LCD indicator will turn off for a few seconds,
then turn on. Make sure that the data indicator displays
“00”. (The mode indicator should still display “63”.)
m
.
If the LCD indicator turns off and does not turns on,
or the data indicator does not display “00”, there may
be a defective part in the circuit. Repair it, then
repeat these steps.
.
In this time, do not press the DATA write (PAUSE)
button.
4-5. After Adjustment Check
To check the values after adjustment, remove the com-
mander and the commander junction fixture from the
camera. Turn off the camera, then turn it on again before
checking.
4-5-1. Checking SYNC Level Adjustment
Check to see if the measured voltage is within the speci-
fied range.
Subject
Free
Measurement point
SYNC level of VIDEO OUT
Equipment
Waveform Monitor
Specification
40
±
4 IRE (NTSC)
286
±
30 mV (PAL)
Lens iris
Close
4-5-2. Checking Burst Level Adjustment
Check to see if the measured voltage is within the speci-
fied range.
Subject
Free
Equipment
Vectorscope
Specification
Burst level is 75%