1-4
SSC-DC132P/134/134P/138P
C
D
E
2)
2
1
1
2
3
4
1)
1
2
3
4
2
3
4
LOCK
1
Mounting the Lens
Compatible lenses
C
1
C mount lens
1) 9 mm (
3
/
8
inch) or less
2
CS mount lens
2) 4 mm (
5
/
32
inch) or less
Notes
• Be sure to attach the lens mount cap when the lens is not mounted.
• Only lenses that are suitable for a 1/3type CCD should be used with
this camera. If lenses for a 2/3type or 1/2type CCD are used, the view
angle will be different.
Fitting the DC servo auto-iris lens plug
D
The camera is supplied with a plug for inserting into the LENS connec-
tor on the side of the camera. When fitting a DC servo auto-iris lens,
you will need to replace the plug on the lens cable with the plug
supplied. Replace as follows:
1
Cover
2
Lens cable
3
Rib (If the cable is thick and the plug cover does not seat properly,
cut away this rib.)
4
Lens plug
1
Remove the plug cover and solder the lens cable wires to the pins
on the plug supplied. The pin assignment is as follows:
2
Put the cover on the plug.
Fitting the lens
E
When using a DC servo auto-iris lens, fit it as follows. For a manual-iris
lens, omit step 3.
1
Unscrew lens mount cap.
2
Screw in the lens.
3
First, replace the plug on the lens cable with the plug supplied with
the camera. Then, connect the camera cable plug to the LENS
socket.
4
Loosen the back focus LOCK screw. Adjust the back focus by
turning the C/CS adjustment ring in accordance with the type of lens
fitted (C-mount or CS-mount). Once adjusted, tighten the back focus
LOCK screw. (The factory setting is CS-mount.)
Caution
When attaching a C-mount type lens, be sure to turn the C/CS adjust-
ment ring fully in the “C” direction. When the C/CS adjustment ring is
set to “CS,” mounting any lens with a mount projection of more than 4
mm may damage the internal parts of the camera.
1
Pin 3:
Drive (+)
2
Pin 1:
Control (–)
3
Pin 2:
Control (+)
4
Pin 4:
Drive (–) (Ground)
4
2
3
1
