Sony STR-DA5400ES, Руководство по эксплуатации

Страница: 116 / 322

116 GB
Tips
• The “LARGE” and “SMALL” settings for each
speaker determine whether the internal sound
processor will cut the bass signal from that
channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the subwoofer or other “LARGE”
speakers.
However, since bass sound has a certain amount of
directionality, it is best not to cut it, if possible.
Therefore, even when using small speakers, you
can set them to “LARGE” if you want to output the
bass frequencies from that speaker. On the other
hand, if you are using a large speaker, but prefer not
to have bass frequencies output from that speaker,
set it to “SMALL.”
If the overall sound level is lower than you prefer,
set all speakers to “LARGE.” If there is not enough
bass, you can use the equalizer to boost the bass
levels.
• The surround back speakers will be set to the same
setting as that of the surround speakers.
• When the front speakers are set to “SMALL,” the
center, surround, and surround back speakers are
also automatically set to “SMALL.”
• If you do not use the subwoofer, the front speakers
are automatically set to “LARGE.”
Lets you set the bass crossover frequency of
speakers that has been set to “SMALL” in the
Speaker menu. Measured speaker crossover
frequency is set for each speaker after the auto
calibration.
1
Press B / b to select the speaker
on the screen you want to
adjust.
2
Press V / v to adjust the value,
then press b .
You can select the test tone type on the Test
Tone screen.
Tips
• To adjust the level of all speakers at the same time,
press MASTER VOL +/–.
• The adjusted value is shown on the display during
adjustment.
To output a test tone from each
speaker
You can output a test tone from the speakers in
sequence.
1
Press B / b to select “Test Tone,” then
press .
The Test Tone screen appears.
2
Press V / v to adjust the parameter, then
press .
• OFF
• AUTO
The test tone is output from each speaker
in sequence.
• L, C, R, SR, SBR, SBL, SL, SW
You can select which speakers will output
the test tone.
3
Press V / v to adjust “Level:,” then press
.
To output a test tone from
adjacent speakers
You can output a test tone from adjacent
speakers so that you can adjust the balance
between the speakers.
1
Press B / b to select “Phase Noise,” then
press .
The Phase Noise screen appears.
2
Press V / v to adjust the parameter, then
press .
• OFF
• L/R, L/C, C/R, R/SL, R/SR, SR/SL, SR/
SBR, SBR/SBL, SR/SB, SBL/SL, SB/
SL, SL/L, L/SR
Lets you output the test tone sequentially
Crossover Freq (Speaker
crossover frequency)
Test Tone