– 26 –
SECTION 4
TEST MODE
Test Mode Operation
1. Handset manual test mode user interface
a) To enter test mode, press and hold # key for 2-3 seconds, then
press 3 key twice with pressing # key. Emits happy tone. Turn
on Tx, Rx at channel 6(1-10). Unmute audio. Lowest PLL
gain mode.
[#]
[3]
[3]
b) Change channel. Refresh PLL ref, rx, tx counters
[CHANNEL]
c) Toggle Tx power. Refresh PLL tx counter.
[PGM]
d) Toggle Rx power. Refresh PLL ref, rx, tx counters.
[SPEED DIAL]
e) Toggle Tx attenuator. Refresh PLL status register
[REDIAL]
f) Change PLL gain mode. Lowest (4 steps)
n
highest.
[TALK]
g) Quit test mode. Emit sad tone.
[OFF]
h) LED indication:
TALK LED “ON”
BATT LOW LED “ON”
Tx Power On
Rx Power On
2. Base manual test mode user interface.
(To enter test mode)
Set the dial mode to TONE, then put the power on with pressing
and holding the PAGE button.
POWER, IN USE, and CHARGE LEDs are turn on and the unit
is in Mode 1 of the test mode. (ITAD block is not in test mode.)
Turn on Tx, Rx at channel 6 (1-10). Unmute audio.
To change the channel in test mode 1, press page button.
Charge Mode
Press and hold the PAGE button for about 3 seconds. You will
change to the next mode once the charge LED change state (ON
n
OFF or OFF
n
ON).
MODE
Charge
FUNCTION
PRESS PAGE
LED
BUTTON
1
ON
Change RF channel
1-10 (default 6)
2
OFF
Toggle RF transmitter power Default on
3
ON
Unused
4
OFF
Generate single tone form
697, 770, 852,
DTMF table for 3 seconds.
941, 1209,1336,
There are 8 tones in the table 1477, 1633,
default is 697
Содержание SPP-930
