Sony SA-F11, Руководство по эксплуатации

Страница: 9 / 92

Basic Operations
9 GB
Troubleshooting
Should you encounter a problem with your speaker
system, check the following list and follow the
indicated measures. If the problem persists, consult
your nearest Sony dealer.
There is no sound from the speaker system.
/ Make sure all the connections are correct.
/
Adjust the volume pressing the LEVEL +/– (or
MASTER VOL +/– on the remote).
/
Make sure the program source selector on the
subwoofer is set to the proper source.
There is no sound from the subwoofer.
/ When you connect the subwoofer to the DVP-F11,
make sure the subwoofer setting is “YES.”
/ When you connect the subwoofer to a component other
than the DVP-F11, connect it to the AUX IN jacks of the
subwoofer.
There is hum or noise in the speaker output.
/ Make sure all the connections are correct.
The sound has suddenly stopped.
/ Make sure all the connections are correct. Contact
between bare speaker wires at the speaker terminals
may cause a short-circuit.
Specifications
SS-MS11 (front speakers)
Speaker system Full range, magnetically shielded
Speaker units 5
×
9 cm, cone type
Enclosure type Bass reflex
Rated impedance 6 ohms
Power handling capacity
Maximum input power:100 watts
Sensitivity level
86 dB (1 W, 1 m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 68
×
151
×
135 mm, including
front grille
Mass Approx. 790 g each
SA-WMS11 (subwoofer)
System
Speaker system Active subwoofer, magnetically shielded
Speaker unit Woofer: 13 cm, cone type, dual voice coil
Enclosure type SAW type
Reproduction frequency range
40 Hz - 200 Hz
Power output
Front 20 W
× 2
Subwoofer 20 W + 20 W
Inputs
DVD IN (input pin jacks)
AUX IN (input pin jacks)
Outputs
SPEAKER OUT (output terminals)
General
Power requirements 220 - 230 V AC, 50/60 Hz
Power consumptions 42 W
Dimensions (w/h/d) Approx. 145
×
237
×
373 mm
Mass Approx. 6.3 kg
Supplied accessories
See page 3.
Design and specifications are subject to change without notice.
Additional Information