3D Shooting Guide Function
89
Ch
apt
er 4
S
hoo
tin
g
When the parallax is too large because the subject
is too close or too far away, a colored outline
around the subject is displayed.
A red outline is displayed when the subject is too
close, and a blue outline when the subject is too
far away.
When a 3D depth warning is displayed, you
should adjust the framing and convergence point
so that the warning is not displayed for an
extended length of time.
To display the 3D depth warning in the
viewfinder, set OPERATION >3D Guide >Depth
Warning VF in the setup menu to On.
The 3D depth warning display can be switched
On and Off during recording by using an
assignable switch with the Depth Warning(VF)
function assignment.
Notes
• The warning may not be displayed correctly,
depending on the subject. Use this function as a guide
when shooting in 3D.
• The 3D depth warning cannot be displayed in
viewfinders other than the supplied viewfinder.
To display the 3D depth warning on a monitor
To display the 3D warning on monitors connected
to the HD/SD SDI OUT(L/R) or HDMI
connectors, set the following parameters to On for
the corresponding monitors using OPERATION
>3D Guide in the setup menu.
• Depth Warning SDI(L)
• Depth Warning SDI(R)
• Depth Warning HDMI
Notes
• The 3D depth warning is not displayed on a monitor
under the following conditions.
- SD signal output to the monitor
- Side-by-side output to the monitor
- Right-side image output to the monitor
- 3G SDI signal output on the HD/SD SDI OUT(L)
connector
• The 3D depth warning displayed in the viewfinder and
on a monitor may vary slightly. Use as a guide when
shooting in 3D.
• Turn the superimposition of text information to Off for
monitors that are to display the 3D depth warning.
Setting the parallax reference
You can set the amount of parallax as a
percentage (%) of the screen width or the
maximum size of the screen as the reference for
calculating the appropriate subject distance using
the 3D shooting guide function.
To set the amount of parallax percentage
1
Set OPERATION >3D Guide >Setting
in the setup menu to %.
2
Set the maximum value of parallax for
close subjects in 3D Guide >Setting
>%(Near), and the maximum value of
parallax for distant subjects in 3D
Guide >Setting >%(Far).
You can set values between 1.0 and 10.0%.
To set the maximum screen size
1
Set OPERATION >3D Guide >Setting
in the setup menu to Screen Size.
2
Select the maximum screen size in 3D
Guide >Setting >Screen Size.
You can select 77, 100, or 200-inch type
screens.
An edge violation occurs when a subject is in
front of the convergence point and is cutoff by the
left or right edges of the frame. When an edge
violation occurs, viewers receive conflicting
depth perceptions that appear unnatural and can
cause discomfort.
The camcorder displays a
v
indicator on the
edges as a warning if an edge violation occurs.
You can keep this phenomenon to a minimum by
heeding edge violation warnings when shooting.
Displaying 3D Depth Warning
Blue outline
Red outline
Displaying the Edge Violation
Warning
Содержание PMW-TD300
Страница 185: ......
