22
Speakers Connection
1. Strip 1/4 inch of insulation off each conductor on both of the 2-conductor cables that run to the speakers in your remote room.
2. Neatly twist the conductor strands so that they won’t fray.
3. Detach the plug-in 4-terminal screw type connector from the “TO SPEAKERS” connector on the in-wall keypad.
4. Loosen the screws on the 4-terminal connector.
5. Insert the four speaker conductors, observing consistent polarity and Left/Right separation and tighten the screws on each
conductor.
A. RED insulation = Right +
B. BLACK insulation = Right -
C. WHITE insulation = Left +
D. GREEN insulation = Left -
6. Failure to wire consistently can result in poor bass sound.
7. Snap the 4-terminal connector back into the “TO SPEAKERS” connector of the in-wall keypad.
Installing the Keypads
1. Place the keypad mounting bracket over the junction box, with the mounting lips facing out.
2. Attach the keypad mounting bracket to the junction box with the four screws as sown below
3. If the mounting bracket does not fit easily, loosen the screws and move the mounting bracket left and right to center it on the junction
box, then retighten the screws.
Installation
