Chapter 11
Setup Menus
Chapter 11
Setup Menus
11-19
Menu items in the range 700 to 799, relating to video control (Continued)
(Items 715 to 721: Settings for controlling the video processing system according to the menu settings)
Item number
Item name
715
VIDEO GAIN CONTROL
716
CHROMA GAIN
CONTROL
717
CHROMA PHASE
CONTROL
718
SETUP LEVEL (525-line
mode)/BLACK LEVEL
(625-line mode)
719
SYSTEM PHASE SYNC
Adjust the output signal sync phase.
–128 to 0 to +127
720
SYSTEM PHASE SC
Adjust the output signal subcarrier phase.
0 to 1023
721
Y/C DELAY
Note
When you make settings for items 715 to 721, set the
function menu item V.PROC to MENU.
When it is set to MENU, all controls for video output
processing on the control panel are disabled.
Menu items in the range 800 to 899, relating to audio control
Settings
Adjust the video output level.
–2048 to 0 to +848
Adjust the chroma output level.
–2048 to 0 to +848
Adjust the chroma phase.
–128 to 0 to +127
Adjust the setup level (black level).
–272 to 0 to +272
For playback from an analog Betacam cassette, adjust the Y/C delay.
–2048 to 0 to +2047
Item name
Settings
Item number
726
H BLANKING WIDTH
Select the horizontal blanking width of the video output signal.
NAROW :
Digital blanking (narrow)
WIDE:
Analog blanking (wide)
When WIDE is selected, the horizontal blanking width complies with RS170A, and
normally the blanking is widened and the image becomes narrower. It is
recommended to select NAROW at the editing stage, then later, for broadcast
transmission to select WIDE, to output a signal conforming to the standard. Note,
however, that NAROW has to be always selected for SDI signals.
728
OUTPUT SCH PHASE
Set the subcarrier H phase.
Default value:
800H
Item name
Settings
Item number
802
DIGITAL AUDIO MUTING
IN SHUTTLE MODE
AUDIO MONITOR
OUTPUT MIXING
Select the audio mixing method used for digital audio signals and Betacam
playback analog audio signals supplied to the MONITOR OUTPUT connector.
ADD:
Simple addition
RMS :
Root-mean-square
AVE:
Simple average
801
DIGITAL JOG SOUND
Turns the digital jog sound on and off.
off:
Digital jog sound is turned off.
Audio of digital channels not subjected to speed correction is output. When the
tape stops, after one second the audio is muted.
on :
Digital jog sound is turned on.
When the tape speed is in the range
×
–1 to
×
1 (for Betacam SX playback, in the
range
×
–1 to
×
2), speed correction is carried out, and the same jog sound as a
conventional analog VTR is output.
Set the digital audio muting conditions during shuttle playback.
off :
Not muted.
CUEUP:
Muted during cue-up or preroll operations.
FULL:
Muted in shuttle mode.
805
(Continued)
733
C.PHASE TYPE–
Select the PAL chroma phase type.
HUE :
Vary the hue.
L.ALT:
Vary the SC phase of composite output.