Ad
minis
tra
ting t
he Camer
a
Setting the Sensor input/Camera tampering detection/Motion detection — Action input Menu
49
Sensor input Tab — Set the sensor
input 1/2/3/4
Sensor input mode
Set the direction of the detected input signal to the
sensor input terminal of the camera.
Normally open:
Triggers an alarm when the sensor
input is short-circuited.
Normally closed:
Triggers an alarm when the sensor
input is open-circuited.
Notes
• Allow at least two seconds for the input signal to be
detected; otherwise, some events may not be detected.
• When you use video streaming by SSL connection, set
as follows. Some events may not be detected if the
camera is not in the following conditions.
– Set the
Bit rate
below 1 Mbps.
– Set the
Frame rate
below 30 fps.
– Use the video streaming below two transmissions at
the same time.
OK/Cancel
See “Buttons common to every menu” on page 21.
Camera tampering detection Tab —
Set the camera tampering detection
Note
Deselect the checkbox of
Stabilizer
in the Installation
tab of the System menu. After setting the camera
tampering detection, set the
Stabilizer
function again.
Enable
Select the checkbox to activate the function to detect
camera tampering, such as direction shifting or spray.
Detection status
Display the tampering detection state of the time when
Camera tampering detection tab is opened. To clear the
detection status, click
Clear
button.
OK/Cancel
See “Buttons common to every menu” on page 21.
Motion detection Tab — Set the
motion/VMF detection
Motion detection responds to moving objects in the
camera image and triggers an alarm.
In VMF, an alarm sounds when motion is detected under
the motion detection setting, entering or passing through
a specified area or inspection line. An alarm also sounds
when an object has been left or removed from a specified
area or inspection line.
The detected object will be displayed on the monitor in
the green frame. The removed object and left object will
be displayed in the magenta frame.
When you click the Motion detection tab, a dialog
appears. Enter the user name and password.
The factory setting of the user name and password for
the Administrator is set to “admin”.
Change the password from the factory setting for the
security of your devices.
Note
Perform the following before setting the motion
detection.
• Deselect the checkbox of
Stabilizer
in the Installation
tab of the System menu.
What is VMF
VMF is a function for detecting an object entering or
passing through a specified area or inspection line, or
when an object has been left or removed from a specified
area or inspection line. Video/audio recording and/or
audio file playback can be synchronized with this alarm.
You can set the inspection methods to execute
independently. Intrusion and Passing can also be set to
execute in combination.
For example:
• An alarm sounds when an object enters areas A, B and
C.
• An alarm sounds when an object passes through area
A and enters area B.
• An alarm sounds when an object passes through areas
A and B, and enters area C.
• An alarm sounds when an object enters area A, and
passes through area B.
Содержание Ipela SNC-WR600
Страница 71: ...Sony Corporation ...
