14
+48V:
To 48 V phantom power to condenser microphones
MIC:
When a microphone-level input is connected
LINE:
When a line-level (0 dBu) signal source is connected
l
REMOTE (remote control) connector (8-pin)
Connect a remote control unit for remote control the camera.
When used in conjunction with the HXCU-FB80, connect with the
REMOTE connector (8-pin) of the sub camera in order to send the
Sub command.
Before connecting/disconnecting a remote control unit, power off the camera
first.
m
TEST OUT connector (BNC type)
Outputs an analog signal.
You can select the VBS signal, Y signal of the VF connector,
HD-SYNC, or SD-SYNC for output in the MAINTENANCE menu.
VBS signal output is not available when HDR is set.
n
SDI OUT connector (BNC type)
Outputs a 3G-SDI signal, HD-SDI, or SD-SDI signal.
You can select the output signal in the MAINTENANCE menu.
o
DC IN (DC power supply input) connector (XLR 4-pin,
female)
To operate the camera from an external DC power supply, connect
an optional DC power cord to this connector and then connect the
cord to an AC-DN10 AC Adaptor or other source.
p
INTERCOM connector (XLR 5-pin)
Connect an XLR 5-pin headset for input and output of intercom
audio signals.
q
AUDIO 2 IN (audio input 2) connector (XLR type, 3-pin,
female)
Connect to audio equipment or a microphone.
When the camera is connected to an HXCU-FB80, the input signal
will be output from the AUDIO OUTPUT CH-2 connector. You can
configure the camera so that the audio is embedded in the output
from the SDI output (MIC2) on the <SDI OUT> page in the
MAINTENANCE menu.
r
Tail guard
Protects the cables connected to the connectors on the rear panel.
s
DC OUT (DC power supply output) connector (4-pin,
female)
Supplies power to a script light or other device (maximum 1.5 A).
t
PROMPTER/GENLOCK (prompter signal output/external
sync signal input) connector (BNC type)
When connected with a CCU, this connector outputs a VBS
prompter signal.
In standalone operation mode, connect an external sync signal (BB
or tri-level sync) for synchronizing the camera. If a VBS signal is
input, you can check the input image in the viewfinder by pressing
the RET button on the camera.
u
SDI I/O connector (BNC type)
The input (IN) and output (OUT) mode can be changed using the
menu.
In standalone operation mode, this displays the HD-SDI signal input
on the SDI I/O connector in the viewfinder when the RET button is
pressed.
You can select the input signal to be displayed in the viewfinder on
the <EXT RETURN> page in the MAINTENANCE menu.
When connected to a CCU, the connector can be used as an HD
PROMPTER output signal connector when set as an output (OUT).
It can be used as an HD TRUNK input signal connector when set as
an input (IN).
Only HD-SDI signals in the same format specified on the <OUTPUT
FORMAT> page in the MAINTENANCE menu can be input on the SDI I/O
connector.
Lens (supplied with the HXC-FB80K/
HXC-FB80S)
For details about attaching a lens, see “Attaching and Adjusting the
Lens” (page 23).
a
RET (return video) button
Displays the return video signal in the viewfinder while this button
is pressed.
b
Zoom see-saw switch
This is enabled when the zoom servo/manual selector knob is in the
SERVO position. The zoom speed increases when you push the
switch deeper, and decreases when you push less deeply.
Note
Note
Note
Содержание HXC-FB80
Страница 71: ...Sony Corporation ...
