Sony HVR M15U - Professional Video Cassete recorder/player, Руководство по обслуживанию, Страница: 138 / 250

6-44
HVR-M15J/M15U/M15N/M15E/M15P/M15C
Note 3: If bit0 of the data is “1”, the EVEN channel is defective.
If bit1 of the data is “1”, the ODD channel is defective.
Contents of the defect is see written into page: C, ad-
dress: 10 and 12. See following table.
(For the bit values, refer to “6-3. SERVICE MODE”,
“3-4. 4. Bit value discrimination”.)
If bit3 of the data is “1”, the tape end being played, so
rewind the tape and perform the adjustment again.
When the EVEN channel is defective
Data of page: C,
Contents of defect
address: 10
EE
Writing into EEP ROM (IC5001) is
defective
E8 Adjustment data is out of range
E7 No data is returned from IC3001
When the ODD channel is defective
Data of page: C,
Contents of defect
address: 12
EE
Writing into EEP ROM (IC5001) is
defective
E8 Adjustment data is out of range
E7 No data is returned from IC3001
2. Switching Position Adjustment (VD-036 board)
RadarW RadarW RadarW
Mode Playback
Signal SW/OL standard (XH2-3)
Measurement Point Displayed data of page: 3, address:
03
Measuring Instrument Adjusting remote commander
Adjustment Page C
Adjustment Address 10, 11, 12, 13
Specified value The data of page: 3, address: 03 is
“00”
Note 1:
Check that the data of page: 0, address: 10 is “00”.
Adjusting method:
Order Page Address Data Procedure
1
Insert the SW/OL standard
tape and enter the VTR stop
mode.
2 0 01 01
3 C 10 EE Press PAUSE (Write) button.
4 3 03 FF
5 3 21 Check the data is “52”. (Note 2)
6 3 01 0D Press PAUSE (Write) button.
7 3 02 Check the data changes to “00”.
8 3 03 Check the data is “00”. (Note 3)
9 0 01 00
Note 2: If the data is “92”, the tape top being played. After play-
ing the tape for 1 to 2 seconds, stop it, perform step 5 and
higher.
If the data is “82”, the tape end being played. After re-
wind the tape, perform step 5 and higher.