5-2 (E)
HXCU-100
3. Disconnect the harness from the connector
CN9 on the CN-3081 board.
4. Remove the UL tape and release the har-
ness from the harness clamp.
5. Remove the three screws and remove the
fan duct.
6. Remove the DC fan from the fan duct.
7. Remove the fan cushion from the DC fan.
8. Install a new DC fan by reversing the steps
above.
n
Carefully install the new DC fan con
fi
rm-
ing the orientation of the label side and the
harness shown in the
fi
gure.
5-3. Removing/Installing
the
Rear Panel Assembly
1. Remove the front assembly.
(Refer to Section 5-1.)
2 Remove the top cover.
(Refer to Section 5-2.)
3. Remove all the screws marked with on
the rear panel assembly.
.
Screw (PSW3
x
6)
x
13
.
Screw (P2.6
x
5)
x
6
.
Hexagon screw
x
8
4. Disconnect
the
fl
exible card wire from the
connector CN10 on the SDI-97 board.
n
Be careful not to bend the
fl
exible card
wire. This shortens the wire life.
5. Disconnect the harness from the connector
CN3 on the CN-3082 board.
6. Disconnect the harness from the connector
CN8 on the CN-3081 board, and remove
the rear panel assembly.
7. Install the removed parts by reversing the
steps above.
PSW3
x
6
Fan cushion
UL tape
DC fan
Label side
Fan duct
CN9
Harness clamp
CN-3081 board
Rear panel assembly
Remove all the screws marked with .
CN10
CN3
CN8
CN-3081
board
SDI-97 board
CN-3082 board
Содержание HKCU-FP1
