Sony HDCU3300 HD, Руководство по обслуживанию

Страница: 35 / 436

3-1 (E)
HDCU3300/MM (J,E)
Section 3
Electrical Alignment
3-1-2. Notes on Adjustments
. Make sure all the measures have already been calibrated.
. Make sure “3-1-4. Initialization Settings” have already
been finished.
.
Make sure the adjustment of the HDC3300 has already
been finished.
. Types of the color bars to be output from the built-in SG:
Signal format Y C
HD-SDI 100 % 100 %
SD-SDI (D1) 100 % 75 %
SD-Composite-analog 75 % 75 % (SMPTE)
(HKCU1001)
SD-Composite-analog 100 % 75 % (EBU)
(HKCU1001)
.
To adjust HDCU3300, extend each plug-in board.
Before pulling out the boards, be sure to turn off the
main power.
.
Before starting adjustment, warm up for about 10
minutes.
. Before using the MSU-900/950, check the version of the
software. For details, refer to Section 1-1, “Checking the
ROM and Software Version” of the separate Installation
Manual for HDCU3300.
3-1. Preparation
3-1-1. Required Equipment
Measures
.
Digital oscilloscope (300 MHz or higher)
Tektronix TDS460A or equivalent
. SD waveform/Vector monitor
Tektronix 1780R or equivalent (for NTSC)
Tektronix 1781R or equivalent (for PAL)
. SD signal generator
Tektronix TSG170A or equivalent (for NTSC)
Tektronix TSG271 or equivalent (for PAL)
.
Audio oscillator
Tektronix SG-5010 or equivalent
. Frequency counter
Advantest TR5821AK or equivalent
Related equipment
. HD color camera (HD super slow motion)
HDC 3300
.
Master setup unit
MSU-900/950
Tools
.
Front extension board EX-982
(Sony P/N : A-1153-700-A)
. Rear extension board EX-983
(Sony P/N : A-1153-701-A)
.
Extension board EX-1002
(for SDP-15 board extension)
(Sony P/N : A-1215-624-A)