Sony Handycam Vision CCD-TRV66E, Руководство по обслуживанию

Страница: 6 / 166

— 6 —
SERVICE NOTE
1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied (8.4V) to the
battery terminal using the service power cord (J-6082-223-A), the
power is shut off so that the unit cannot operate.
This following two methods are available to prevent this. Take note
of which to use during repairs.
Method 1.
Connect the servicing remote commander RM-95 (J-6082-053-B)
to the LANC jack, and set the remote commander switch to the
“ADJ” side.
Method 2.
Press the battery switch of the battery terminal using adhesive tape,
etc.
Method 3.
Use the DC IN terminal. (Use the AC power adaptor.)
6
Pull the timing belt in the direction of
arrow
A
with a pinsette while pressing
the cassette lid (take care not to damage)
to adjust the bending of a tape.
7
Let go your hold the cassette
lid and rise the cassette
compartment to take out a cassette.
Pinsette
Timing belt
Timing belt
Press the cassette lid to rise
the cassette compartment
[DC power supply]
(+5V)
Adjust the bending of a tape
Disconnect CN901
of VC-214 board.
Loading motor
DC IN terminal
Battery switch
Battery terminal ’
Battery terminal ‘
Battery SIG terminal
2. TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1
Refer to 2-1. to remove the front panel assembly.
2
Refer to 2-1. to remove the cabinet (R) assembly.
3
Refer to 2-1. to remove the battery panel assembly.
4
Refer to 2-1. to remove the cabinet (L) assembly.
5
Disconnect CN901 of VC-214 board.
6
Add +5V from the DC POWER SUPPLY and unload with a
pressing the cassette lid.