Sony Handycam Vision CCD-TRV66E, Руководство по обслуживанию

Страница: 123 / 166

5-41
A
1.35
µ
sec
Center of the luminance line width
Fig. 5-3-14.
9. REC C Current Adjustment (VC-214 board)
Set the recording current levels of the REC Chroma signal. If it is
too low, chroma signal noise in played back picture will increased.
If too high, Y signal noises will increase and white modulation noises
will be produced.
Mode VTR recording (SP mode)
Signal No signal
Measurement Point Pin
0
of CN910 (REC RF)
Measuring Instrument Oscilloscope
Adjustment Page F
Adjustment Address 85
Specified Value A=35.7 ± 1.3mV
Connection:
1)
Remove C085 (0.01
µ
F, Pin
!§
of IC202).
Note:
After completing “REC L Level Adjustment” and “REC C
Current Adjustment”, replace C085 with new parts (1-162-970-
11 CERAMIC CHIP 0.01
µ
F 10% 25V).
2) Connect Pin
$∞
of IC001 and GND with a 0.01F capacitor.
0.01
µ
F capacitor: 1-101-004-00
Preparations only for the model without REC switch:
1)
Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 14, after memorizing the data, set the
bit value of bit1 to “1”. (Refer to “4-3, 3. Bit value
discrimination” of “5-4. Service Mode”).
3) Insert a tape, and set to recording mode. (Use the wireless
remote commander of 8mm VCR.)
Adjusting method:
1)
Insert a tape, and set to recording mode.
2) Select page: 0, address: 01, and set data: 01.
3) Select page: 2, address: 01, set data: 41, and press the PAUSE
button of the adjustment remote commander.
4) Select page: 6, address: 61, and set data: 30.
5) Select page: F, address: DE, after note down the data, set data:
00, and press the PAUSE button of the adjustment remote
commander.
6) Select page: F, address: 85, change the data and set the REC
chroma signal level (A) to the specified value.
7) Press the PAUSE button of the adjustment remote commander.
8) Select page: F, address: DE, set the data noted down at step 5),
and press the PAUSE button of the adjustment remote
commander.
9) Select page: 6, address: 61, and set data: 10.
10) Select page: 2, address: 01, set data: 00, and press the PAUSE
button of the adjustment remote commander.
11) Select page: 0, address: 01, and set data: 00.
Processing after completed adjustment only for the model
without REC switch:
1)
Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 14, and set the data memorized at step
2) of “Preparations only for the model without REC switch”.
3) Press the PAUSE button of the adjustment remote commander.
4) Select page: 0, address: 01, and set data: 00.