Sony GV-D300 Operating Instructions (primary manual), Руководство по обслуживанию

Страница: 80 / 148

5-16
3-5-2. Clock Adjustments
1. IC1900 27MHz XTAL f
0
Adjustment (RJ-77 Board)
Set the sub-carrier frequency of the video output signal in the VTR
mode.
Mode VTR stop
Signal No signal
Measurement Point Pin
#∞
of CN9921 on CB-61 board
(CK135) or R1114 (Pin
`⁄‚⁄
of
IC1101)
Measuring Instrument Frequency counter
Adjustment Page D
Adjustment Address 98
Specified Value f = 13500000 ± 68 Hz (NTSC)
f = 13500000 ± 68 Hz (PAL)
Adjusting method:
1)
Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 15, after memorizing the data, set the
bit value of bit2 to “0”. (Refer to “4-3, 3. Bit value
discrimination” of “5-4. Service Mode”).
3) Select page: D, address: 98, change the data and set the clock
frequency (f) to the specified value.
4) Press the PAUSE button of the adjustment remote commander.
5) Select page: D, address: 15, and set the data memorized at
step 2). Press the PAUSE button of the adjustment remote
commander.
6) Select page: 0, address: 01, and set data: 00.
2. IC1900 VCO Operation Check (RJ-77 Board)
Mode VTR stop
Signal No signal
Measurement Point Display data of page: 2, address: 0E
Measuring Instrument Adjustment remote commander
Specified Value “C0” to “FF”
Adjusting method:
1)
Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 15, after memorizing the data, set the
bit value of bit2 to “0”. (Refer to “4-3, 3. Bit value
discrimination” of “5-4. Service Mode”).
3) Select page: 2, address: 05, set data: 02, and press the PAUSE
button of the adjustment remote commander.
4) Select page: D, address: B0, set data: 03, and press the PAUSE
button.
5) Select page: 2, address: 0E, and check that the data is “C0” to
“FF”.
6) Select page: D, address: B0, set data: 05, and press the PAUSE
button.
7) Select page: 2, address: 0E, and check that the data is “C0” to
“FF”.
8) Select page: D, address: B0, set data: 00, and press the PAUSE
button.
9) Select page: 2, address: 05, set data: 00, and press the PAUSE
button.
10) Select page: D, address: 15, and set the data memorized at
step 2).
11) Select page: 0, address: 01, and set data: 00.
3. IC6101 41.85MHz VCO Operation Check (RJ-77 Board)
Mode VTR stop
Signal No signal
Measurement Point Display data of page: 3, address: 39
Measuring Instrument Adjustment remote commander
Specified Value “37” to “C9”
Checking method:
1)
Select page: 3, address: 39, and check that the data is “37” to
“C9”.