Sony FWD-S42E1, Руководство по эксплуатации

Страница: 70 / 256

28
GB
FWD-S42E1
4-160-338- 02 (1)
Adv
a
nc
e
d
S
e
tu
p
RGB Signal Select “PC” or “Video” for whether it works as a PC signal or a video signal when
a 1280 × 768/60 or 720 × 480/60 RGB signal is input to the HD15 (RGB/
COMPONENT) IN connector or DVI IN connector of the display or the HDMI
input connector of the optional adaptor BKM-FW15 or the BNC input connector of
the optional adaptor BKM-FW11. You can independently set the most suitable
setting for each selected input connector.
HD15/DVI/HDMI
Screen Saver This is a setting to prevent or reduce screen burn or after-image that can occur by
long periods of screen display of the same image.
Off Screen saver function will not work.
All White Displays an all-white screen. (Stops automatically after about 30 minutes and the
display enters standby mode.)
Sweep Scrolls a white bar over the screen.
Standby Turns on a screensaver for the time set in “Timer Setting” in standby (page 9). (The
display is blank during screensaver operation.) When the set time has passed, the
display returns to the regular standby state.
Menu Position Change the menu screen’s direction to match the display’s installed direction.
Landscape Shows the menu screen horizontally.
Portrait Shows the menu screen vertically.
On-Screen Logo Select “On” or “Off”. If you select “On”, the logo is displayed when a signal is not
inputted.
IP Address Setup Sets an IP address to enable communication between the Network connector of the
optional adaptor and the equipment such as a PC connected with the LAN cable.
For details on how to make the settings, see the section of “Preparations for Using
the Network Functions” (page 30).
You can only use this if the optional adaptor BKM-FW32/FW50/FW55 is attached.
Speed Setup Sets a communication speed between the Network connector of the optional
adaptor and the equipment such as a PC connected with the LAN cable.
For details on how to make the settings, see the section of “Preparations for Using
the Network Functions” (page 30).
You can only use this if the optional adaptor BKM-FW32/FW50/FW55 is attached.
Power On Delay Adjusts the time from when the display is switched on until it actually turns on. Sets
to Off, and 1 to 120 seconds. This suppresses a sudden load fluctuation to the power
equipment when multiple units are connected.
HDMI Control If you connect HDMI control compatible equipment to the HDMI input connector
of the optional adaptor, then the equipment can be controlled together.
• You can only use this if the optional adaptor BKM-FW15 (serial no. 7000001
onwards) is attached.
• You should use the remote control to switch on/off the display and connected
equipment.
HDMI Control Select “On” or “Off”. If you select “On”, then HDMI equipment control works, and
it can be set to “Auto Device Off” and “Auto Display On”.
• If it does not work, also set HDMI settings on the connected equipment.
• To control it, the connected equipment must be HDMI control compatible, and
it must be set to enable HDMI equipment control.
• Depending on the HDMI equipment, this may not operate together with this
device in some cases.
Menu Function and operation
Note
Note
Notes
Notes
02GB060MEN.fm Page 28 Friday, December 18, 2009 3:06 PM