Sony FH300L - VPL - LCD Projector, Руководство по эксплуатации, Страница: 14 / 68

14
Location and Function of Controls
a
? / 1 (On/Standby) key
Turns on the projector when it is in
standby mode. When you push this key,
the ON/STANDBY indicator flashes in
green and then lights in green when the
projector is ready to operate.
To turn off the power, press the
? / 1 key
twice according to the message or hold
the
? / 1 key for about one second.
b
ON/STANDBY indicator
Lights up or flashes under the following
conditions:
•
Lights in red when the AC power cord
is plugged into a wall outlet. Once the
projector is in standby mode, you can
turn it on with the
? / 1 key.
• Flashes in red when the internal
temperature is high or the electrical
system has failed.
• Lights in green when the projector is
turned on, and when it is ready to
operate.
• Flashes in green from the time when
the projector is turned on until the
projector is ready to operate. Also,
flashes in green while the cooling fan
is running after the power is turned off
with the
? / 1 key. The fan runs for
about 90 seconds after the power is
turned off.
• Lights in orange when the power
saving mode is on.
For details, see the “Turning Off the
Power” on page 27 and “Replacing the
Lamp (s)” on page 46.
c
PIC MUTING (picture muting)
indicator
Shows that the picture is muted by
pressing the MUTING PIC button on the
Remote Commander when this indicator
is lighting in orange.
There are two muting modes in this
projector. The image muting mode
mutes the image signal, and the shutter
muting mode cuts the projecting picture
by the shutter inside the lens. The picture
is muted by the mode selected in the
“Picture Muting Mode” of the Setup
menu.
For details, see the “PIC (Picture)
Muting Mode” on page 38.
d
LAMP/COVER indicators
Flashes in orange under the following
conditions:
•
A reception rate of 2 flashes when
the lamp cover or air filter cover is not
secured firmly.
• A reception rate of 3 flashes when
the lamp has reached the end of its life
or reaches a high temperature.
• A reception rate of 4 flashes when
the shutter does not work properly.
Note that it does not flash when the
shutter is open.
For details, see “Replacing the
Lamp (s)” on page 46.
e
LAMP1, 2 indicators
Shows the lamp which has not lit.
•
LAMP1 lights in orange when
LAMP1 has not lit.
• LAMP2 lights in orange when
LAMP2 has not lit.
• Both LAMP1 and 2 light on orange
when LAMP1 and LAMP2 have not
lit.
For details, see “The Installation Menu”
on page 42.
B
Power/Indicator
ON/STANDBY
PIC MUTING
LAMP/COVER
LAMP
1 2
4
3
2
1
5