Sony DWZB70HL, Руководство по эксплуатации

Страница: 12 / 29

Power Supply
12
The display disappears after about 10 seconds. You can
display it again by pressing the channel selection button.
For details on the channel display, see “Channel
Display” (page 18).
k
CHANNEL SELECT button
Allows you to select the RF mode and the transmitting
channel.
For details on selecting the RF mode and transmitting
channel, see “Configuring the Transmitting Channel
Settings” (page 17).
Half-rack receiver (receiver: ZRX-HR70)
For details on the half-rack receiver, see “ZRX-HR70
half-rack receiver” (page 27) for the DWZ-M70.
Power Supply
This section describes the power supply for each device.
For details on how to insert batteries, see “Inserting
Batteries” (page 12).
Handheld microphone (ZTX-M02RC),
body-pack transmitter (ZTX-B02RC)
Power supplied by two LR6 (size AA) batteries.
The following types of battery can be used.
• Alkaline dry cell batteries
• Rechargeable nickel-metal hydride batteries
• Lithium batteries
Half-rack receiver (ZRX-HR70)
Power supplied by the supplied AC adapter.
Inserting Batteries
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law
in the relative area or country.
• Always use sets of the same type of battery. Do not use
batteries of different types or remaining charges
together as a set.
• Replacing the batteries during operation will result in
high noise. Be sure to turn off the unit before replacing
the batteries.
Handheld microphone (ZTX-M02RC)
1
Slide the POWER switch to turn off the unit.
2
Turn the grip in the direction of the arrow, and pull
down the grip until the battery compartment is shown.
Notes