Sony DWZB70HL, Руководство по эксплуатации

Страница: 17 / 29

Transmitter Settings
17
4
Select the frequency for which you want to adjust the
level, and adjust the setting.
5
Select [Set].
The setting value is saved.
To cancel the setting, press the ESC button.
Configuring the transmitter muting
function for the output connectors
You can select whether to enable the muting function
controlled by the transmitter for the audio output of each
output connector.
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [TX Muting].
The [Apply TX Muting] screen appears.
3
Select the connectors for which you want the muting
function enabled.
This completes the configuration, and the main
screen appears again.
Configuring the battery type
Specify the type of battery that is being used in the
transmitter so that the transmitter’s remaining battery
charge can be displayed properly on this unit.
1
In the [Setup] screen, select [Advanced Settings].
2
Select [Battery Type].
3
Select the battery type.
Alkaline: Alkaline dry cell batteries are being used in
the transmitter.
Ni-MH: Rechargeable nickel-metal hydride batteries
are being used in the transmitter.
Lithium: Lithium batteries are being used in the
transmitter.
This completes the configuration, and the main
screen appears again.
Transmitter Settings
Configuring the Transmitting
Channel Settings
Two RF modes (channel modes), wide band and narrow
band, are available on the DWZ.
Each RF mode consists of six channels. Select the
appropriate channel according to your intended use.
The two RF modes, wide band and narrow band, cannot
be used simultaneously. Select only one RF mode during
use.
Selecting the RF mode
1
Turn off the unit.
To turn off the ZTX-M02RC, slide the POWER
switch to the OFF position.
To turn off the ZTX-B02RC, press and hold the
POWER/MUTING button.
2
For the ZTX-M02RC, slide the POWER switch to the
ON position while holding down the channel
selection button.
For the ZTX-B02RC, press and hold the POWER/
MUTING button (about 1 second) while holding
down the channel selection button.
“0” blinks in the channel display.
3
Press the channel selection button to select “1” or “a.”
4
Press and hold the channel selection button.
Selecting the channel
1
Press and hold the channel selection button while the
unit is turned on.
The channel display blinks.
2
Press the channel selection button to select the
channel.
Screen display
Connector
To All
Outputs To
Balanced
& Main
Only To
AUX/
Tuner
Only
BALANCED OUTPUT
Enabled
Enabled
–
UNBALANCED
OUTPUT MAIN
–
UNBALANCED
OUTPUT AUX/
TUNER
– Enabled
RF mode Transmitting
channel number Description
Wide band
(WIDE) 1/2/3/4/5/6 This mode reduces any
interference to other
wireless equipment.
Narrow band
(NARROW) a/b/c/d/e/f This mode uses the Clear
Channel Scan function,
making it useful for
avoiding any interference
from other wireless
equipment.
Caution