Sony DWM-02, Руководство по эксплуатации

Страница: 21 / 36

21 Setting Menus
Setting Menus
The functions and parameters of the settings
menu are explained here. Underlined items
are the factory setting.
Naming of Microphone
(NAME)
You can specify a microphone name of up
to 16 characters. The factory setting for the
microphone name is the model name and
serial number. The microphone name is
sent to the receiver as metadata and is used
by the receiver to distinguish between
different microphones/transmitters.
+:
The first press on the + button displays
the character set. You can then use the + and
– buttons to select the desired character.
And then, pressing the SET button adds the
selected character to the end of the current
name.
– :
Deletes the last character in the current
name.
SET:
Enters the character or edited name.
You cannot insert or delete a character in
the middle of the name.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
“Using the Cross Remote” on page 15.
To edit with a keyboard
You can enter data from an optional
keyboard connected to the USB connector.
For details, see “Using a USB Keyboard” on
page 19.
Selecting the Frequency
Band
(BAND)
Match the frequency range on this
microphone to that of the Sony digital
wireless receiver.
See “Carrier Frequencies and Channel
Steps” on page 32 for differences in
frequency ranges that can be set for optional
receivers combined with this transmitter.
For details about the frequency range of each band,
refer to “Sony Digital Wireless Microphone System
Frequency Lists” on the supplied CD-ROM.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
“Using the Cross Remote” on page 15.
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the microphone first. Then, while
holding down the SET button, turn the
power on. Then change the setting after
the signal transmission has stopped.
• Be sure to select the group/channel right
after selecting the frequency band. To
start signal transmission with the selected
frequency band/group/channel, turn off
the power and then turn it on again.
Selecting the Group/
Channel
(GP/CH)
See “Carrier Frequencies and Channel
Steps” on page 32 for factory settings.
For details, see “Selecting the Group/Channel” on
page 14.
Note
Notes