Sony DWM-02, Руководство по эксплуатации

Страница: 15 / 36

15 Using the Cross Remote
Using the Cross
Remote
This microphone is equipped with a
wireless remote control function that can be
used to set the parameters (low-cut filter,
attenuation operation, power save mode,
etc.) of the microphone through the receiver
or other devices. This function makes it
easier to operate and manage the
microphone system while in the field.
This wireless control is 2.4 GHz
IEEE802.15.4 compliant and has no effect
on the RF band of digital wireless audio.
This function is activated when pairing is
established between the microphone and
the receiver using the RF REMOTE
function.
Pairing must be done first before the
wireless remote control function can be
used.
If “RESTRICTED BY GP/CH SETTING”
appears on the RF REMOTE screen, the
wireless remote control function cannot be
used. To use the wireless remote control
function, select a different transmission
channel.
For details on how to change the transmission
channel, see “Setting the Transmission Channel” on
page 13.
Pairing With a Receiver
Pairing links the microphone with the
receiver which the wireless remote control
function is to be used.
When the microphone has been paired with
a receiver through the receiver operation,
turning on the microphone while holding
down the – button establishes the pairing
immediately.
To carry out pairing through menu
operations on the microphone, do the
following.
1
Set the receiver to be used for
controlling the microphone to pairing
mode.
For details, refer to the operating instructions
supplied with the receiver.
2
Press the + or – button repeatedly until
the RF REMOTE indication is
displayed.
3
Hold down the SET button until the
item to be set flashes.
4
Press the + or – button repeatedly to
select PAIRING.
5
Press the SET button to enter.
The microphone sends a pairing
request to the receiver which is on
pairing mode.
Before established pairing, if you press
any operation key on the microphone,
pairing mode will be cancelled.
When pairing has been established, the
wireless remote control condition level
(indicated by
) goes up, RF
REMOTE turns on, and the remote
control function becomes operative.
When “Pairing fail” is
displayed
• Successful communication between the
microphone and the receiver did not
occur within a given amount of time.
Perform pairing again.
• Pairing has been performed with the grip
open. When the internal antenna is
covered with the grip, pairing may not be
Note