Chapter 2
Location and Function of Parts
Chapter 2
Location and Function of Parts
2-11
5
STOP button
To stop recording or playback, press this button,
turning it on.
When you stop playback, the unit switches either to
still playback or to E-E mode according to the setting
on function menu HOME page for F2 (PB/EE) and the
setting of setup menu item 108.
Fault display function
The STOP button flashes in the following cases related
to reference signals:
• When F2 (OUTREF) is set to INPUT on function
menu page 4, and there is no input video signal.
• When F2 (OUTREF) is set to REF in function menu
page 4, and there is no external reference signal input
or the input external reference signal is not
synchronized to the input video signal.
6
F FWD (fast forward) button
To fast forward the tape, press this button, turning it
on.
7
PLAY button
To start playback, press this button, turning it on.
To operate in capstan override mode
Hold down this button, and turn the search dial.
For details of capstan override mode, see page 4-9.
8
SERVO indicator
Lights when the drum servo and capstan servo are
locked.
9
REW (rewind) button
To rewind the tape, press this button, turning it on.
q;
Editing mode setting section
1
ASSEMBLE button
Press this button, turning it on, to carry out assemble
editing
1)
.
All signals (video signals, audio signals, time code
signals, and so on) are recorded together.
Press the button again, turning it off, to exit from
assemble editing mode.
Note
When even one of the INSERT buttons is lit, the
ASSEMBLE button does not work. To use the
ASSEMBLE button, turn off all the lit INSERT
buttons.
2
INSERT buttons
Press the corresponding button, turning it on, to select
a signal for insert editing
2)
. Press the button again,
turning it off, to cancel the selection.
VIDEO button: Selects the video signal.
TC (time code) button: Selects time code.
CH1 to CH4 (audio channels 1 to 4) buttons:
Select the signals on audio channels 1 to 4.
CUE button: Selects the cue audio signal.
Note
When the ASSEMBLE button is lit, none of the
INSERT buttons work. To use INSERT buttons, press
the ASSEMBLE button, turning it off.
qa
ALARM indicator and KEY INHI
indicator
ALARM indicator
This lights when a hardware error is detected on the
unit, and goes off when the error is resolved.
When this indicator is lit, an error message appears in
the time data/menu display section. If you are using
the SDI OUTPUT 3 (SUPER) or COMPOSITE
VIDEO OUTPUT 3 (SUPER) connector, then when
the setting of F4 (CHARA) in function menu page 4 is
ON, the error message also appears on the monitor
screen.
For details on error messages, refer to Section 1-24 in the
Maintenance Manual Volume 1.
VIDEO
TC
CH1
CUE
CH2
CH3
CH4
INSERT
ASSEMBLE
2
INSERT buttons
1
ASSEMBLE button
1) Assemble editing: Editing in which new video/audio is
added in sequence to the end of existing recorded video/
audio.
..........................................................................................................................................................................................................
2) Insert editing: Editing in which new video/audio is added
to an intermediate position of existing recorded video/
audio.
