Sony CMT-M700DVD, Руководство по эксплуатации, Страница: 79 / 96

79
GB
CMT-M700DVD 4-240-065-11(1) GB
Troubleshooting
Optional components
There is no sound.
• Refer to General item “There is no sound.” on
page 76 and check the condition of the system.
• Connect the component properly (see page 73)
while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
• Press FUNCTION repeatedly to select
“OPTICAL IN” or “ANALOG IN”.
The sound is distorted.
• Set the volume of the connected component
lower.
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (see page 61).
• Connect the antenna properly (see page 9).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend
you connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend
it fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical
equipments.
A stereo FM program cannot be received in
stereo.
• Press REPEAT/FM MODE until “STEREO”
appears in the display.
Cyclical static noise is heard while recording on
an MD.
• Adjust the antenna orientation and position until
the noise stops.
If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1
Disconnect the mains lead.
2
Reconnect the mains lead.
3
Press ?/1 to turn on the system.
4
Press x , ENTER/START and ?/1 .
The system is reset to the factory settings
except for DVD settings. You should set the
settings you made, such as the preset stations,
clock, and timer.
To reset the DVD settings, select “RESET” in
step 3 of “Using the Setup Display” (page 19).
After you select “RESET” and press ENTER,
select “YES”, then press ENTER to reset the
settings (it takes a few seconds to complete).
Do not press
?/1 when resetting the system.