Sony CMT-M700DVD, Руководство по эксплуатации, Страница: 61 / 96

61
GB
Tuner
CMT-M700DVD 4-240-065-11(1) GB
6
Press /– (or TUNER +/– on the
remote) repeatedly to select the desired
preset station.
7
Press ENTER/YES on the remote.
8
Repeat steps 1 through 7 to preset
other stations.
Other Operations
To
Tune in a station
with a weak
signal
Set another station
to the existing
preset number
To change the AM tuning interval
(Except for European model)
The AM tuning interval is factory-preset to 9 kHz (or
10 kHz for some areas). To change the AM tuning
interval, tune in any AM station first, then turn off the
system. While holding REPEAT/FM MODE, press
?/1 . When you change the interval, all the AM
preset stations are erased. To reset the interval, tune
in any AM station first, then turn off the system.
While holding REPEAT/FM MODE, press
?/1 .
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power
failure occurs.
• You can label the preset stations (page 62).
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
Do this
Follow the procedure described
in “Setting presets through
manual tuning”.
After step 5, press /–
(or TUNER +/– on the remote)
repeatedly to select the preset
number you want to store the
station.
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 60).
1
Press TUNER BAND repeatedly to
select FM or AM.
2
Press TUNING MODE (or PLAY MODE/
TUNING MODE on the remote)
repeatedly until “PRESET” appears in
the display.
3
Press /– (or TUNER +/– on the
remote) repeatedly to select the desired
preset station.
To select the desired preset number
using the numeric buttons on the
remote
Press numeric buttons instead of performing
step 3.
To enter preset number 10 or higher, press >10
and the corresponding numeric buttons. To
enter 0, press 10/0.
Example:
To enter preset number 20, press >10, then 2 and
10/0.
continued