Sony CMT-L7HD - Micro Hi Fi Component System, Руководство по эксплуатации

Страница: 64 / 68

64
GB
Additional Information
Precautions
The nameplate is located on the rear exterior.
On operating voltage
Before operating the system, check that the operating
voltage of your system is identical with the voltage of
your local power supply.
On safety
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Be sure to turn off the system before disconnecting
the power cord.
• Unplug the system from the wall outlet (mains) if it
will not be used for an extended period of time. To
disconnect the power cord (mains lead), pull it out
by the plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
system, unplug the system and have it checked by
qualified personnel before operating it any further.
• AC power cord must be changed only at the
qualified service shop.
On placement
• Do not place the system in an inclined position.
• Do not place the system in locations where it is:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight
On heat buildup
• Although the unit heats up during operation, this is
not a malfunction.
• To prevent heat build-up in the system, place the
system in a location with adequate ventilation and
refrain from placing anything on the top of the
cabinet.
If you continuously use this system at a large volume,
the cabinet temperature of the top, side and bottom
rises considerably. To avoid burning yourself, do not
touch the cabinet.
To prevent a malfunction, do not cover the ventilation
hole for the cooling fan.
On operation
If the system is brought directly from a cold place to a
warm place, or is placed in a very damp room,
moisture may condense on the lens inside the system.
Should this occur, the system will not operate
properly. Remove the CD and leave the system
turned on for about an hour until the moisture
evaporates.
If you have any questions or problems concerning
your system, please consult your nearest Sony dealer.
On the speaker system
Although this speaker system is magnetically
shielded, there may be cases where the picture on
some TV sets becomes magnetically distorted. In
such a case, turn off the power of the TV set, and
after 15 to 30 minutes turn it on again.
If there seems to be no improvement,
locate
the speaker system further away from the TV set.
Also, be sure not to place objects in which magnets
are attached or used near the speaker system, such as
audio racks, TV stands, and toys. These may cause
magnetic distortion to the picture due to their
interaction with the system.
Notes on CDs
• Before playing a CD, clean the CD surface with a
cleaning cloth. Wipe the CD from the center out.
• Do not play a CD with tape, stickers, or adhesives
on any of its surfaces as this may damage the
system.
• Do not use solvents.
• Do not expose the CDs to direct sunlight or heat
sources.
• Discs with non-standard shapes (e.g., heart, square,
star) cannot be played on this system. Attempting
to do so may damage the system. Do not use such
discs.
Note on CD-R/CD-RW play
Discs recorded on CD-R/CD-RW drives may not be
played back because of scratches, dirt, recording
condition or the drive’s characteristics. Besides, the
discs, which are not yet finalized at the end of
recording, cannot be played back.
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do
not use any type of abrasive pad, scouring powder or
solvent such as thinner, benzene or alcohol.
Note on High-Speed Synchro
Storage
Certain CD conditions may cause sound dropout
or noise in the recording results, or even create
unwanted tracks on the HD. If this happens, clean
the CD as instructed on “Notes on CDs” on this
page, and record material to the HD using Auto
Storage only.