Sony CMT-EX5 - Micro Hi Fi Component System, Руководство по эксплуатации

Страница: 25 / 28

Additional Information
25 GB
Self-diagnosis display
Messages
One of the following messages may appear or
flash in the display during operations.
CD
Complete!
CD editing (Disc Memo) finished normally.
File Full
There are already 100 disc titles stored in the
system.
Initialize
The system is being initialized. You cannot load a
CD during this time. Wait until “Initialize”
disappears.
No Disc
There is no disc in the CD player.
—OVER—
You have reached the end of the CD while
pressing and holding down
M
during playing
pause.
Push STOP!
You pressed PLAY MODE on the remote during
play.
Step Full!
You tried to program 26 or more tracks (steps).
Additional Information
Precautions
The nameplate is located on the bottom exterior.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Discard used
batteries according to the manufacturer’s instructions.
On operating voltage
Before operating the system, check that the operating
voltage of your system is identical with the voltage of
your local power supply.
On safety
• The front cover is made of tempered glass.
Under normal conditions, this tempered glass is
more shock resistant and able to bear more weight
than ordinary glass. This glass, however, may
shatter if it receives a sharp blow or if it is
scratched.
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Unplug the system from the wall outlet (mains) if it
is not to be used for an extended period of time. To
disconnect the power cord (mains lead), pull it out
by the plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
system, unplug the system and have it checked by
qualified personnel before operating it any further.
• AC power cord must be changed only at the
qualified service shop.
On placement
• Do not place the system in an inclined position.
• Do not place the system in locations where it is:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight.
• Use caution when placing the unit or speakers on
surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloration of the
surface may result.
continued