Sony CineAlta HDCAM HDW-F900R, Руководство по обслуживанию

Страница: 423 / 546

8-17
HDW-F900R/V1 (E)
S
T slider Manual eject gear (A)
T slider assembly
T gear assembly
Intermittent gear (the white gear that can be seen
from the clearance of the T slider assembly)
Open
Adjustment Procedure
3. S gear assembly adjustment
(1) Remove the S slider assembly.
(Refer to Section 7-32.)
(2) Rotate the manual eject gear (A) counter-
clockwise until the mechanism reaches the
threading-end state.
(Confirm that the intermittent gear stops
rotating and the specified portion of the T
gear assembly shown in the illustration, has
fully opened.)
c
Do not rotate the intermittent gear after the
mechanism has reached the threading end
state. If the intermittent gear is kept rotating,
it will damage the mechanical parts.
(3) To adjust coupling between the gears, slip off
and on the S gear assembly until the round
hole of the S gear assembly faces right
opposite to the trapezoidal hole of the sub
cam gear. (Fig. 1)
(4) Insert the parallel pin (d = 2.0 mm) into the
hole of the S gear assembly and the hole of
the mechanism frame. (Fig. 2)
Confirm that the round hole of the S gear
assembly faces right opposite to the
trapezoidal hole of the sub cam gear. (Fig. 1)
(5) Repeat steps (3) and (4) until the mechanism
state described in step (4) is obtained.
(6) When the adjustment is complete, remove the
parallel pin and attach the S slider assembly.
(Refer to Section 7-32.)
S
S
S
S gear
assembly
Sub cam gear
Fig. 1 Fig. 2
Round hole
Trapezoidal
hole
Sub cam gear
S gear
assembly
Parallel pin
(d = 2.0 mm)
S gear
assembly
Hole
Hole of mechanism
frame