Sony CineAlta HDCAM HDW-F900R, Руководство по обслуживанию

Страница: 29 / 546

1-19
HDW-F900R/V1 (E)
4. Remove the three precision screws (P1.4
x
3.5) and
move the cassette compartment assembly by holding
the specified position as shown in the illustration and
remove the cassette compartment assembly in the
direction of the arrow.
Reinstallation
1. Adjust position of the joint arm so that the gap be-
tween the outside circumference of the white roller of
the joint arm and the end surface of the mechanical
deck assembly is 0.5 mm.
1-9. Removing and Reinstalling the
Cassette Compartment
m
.
Be sure to set the POWER switch to OFF, unplug the
power cord or remove the battery before starting any of
the following procedure to protect inside of the unit from
damage.
.
Only when the release plate is attached to the T-tension
regulator assembly, remove and reinstall the Cassette
compartment assembly at the thread position shown in
the illustration below. When the TC head is at the other
position, T-tension regulator assembly interferes with the
cassette compartment.
n
.
Cassette compartment can be removed when it is raised
up or when it pushed down.
Removal
1. Remove the outside panel assembly.
(Refer to Section 1-4.)
2. Remove the FL-283 printed wiring board from the
connector (CN1) on the CCM-45G board.
3. Remove the FL-283 printed wiring board while
removing the cable retainer 2 from the notch.
n
Life of the FL-283 printed wiring board will be
significantly shortened if it is folded. Be very careful
not to fold the FL-283 printed wiring board.
T slider (at the front of the TC head)
S slider
TC head
CCM-45G board
CN1
FL-283 printed wiring board
Notch
Cable retainer 2
Cassette compartment
assembly
Mechanical deck
assembly
Precision screw
P1.4
x 3.5
Precision screws
P1.4
x 3.5
0.5 mm
Roller (WHT)
Joint arm