2-4
CCP-1100SF
2-3.
Reel table assembly position
There are two methods available for replacing the reel table.
2-4. Assembly of capstan motor and
motor pully
Insert slowly the motor pulley into the capstan motor shaft,
and tighten hexagonal socket head screw where the pulley
is stopped.
Relative position between capstan motor and pulley is as
shown in the figure.
Gray
2.3 mm
A : Reel table (L) Assy
C : Height from chassis
Black
B : Reel table (R) Assy
20 mm
0.6 mm
1.
When reel table assembly is mounted on the stand
alone motor. (in case of motor change, etc.)
Relative position between reel table and stand alone
motor is A and B shown in the figure.
2.
Positioning from chassis. (if motor is attached to chassis.)
The distance from chassis to reel table top is 20 mm as
shown figure(C).
Note : 1. After replacement, confirm that the motor does not contact the reel
table assembly.
2. Tighten the reel table assembly fixing screws (hex. socket head
setscrew 2x3) with a hex. wrench.
3. The left motor shaft is locally planed, and one of two setscrews
should be positioned here.
Motor shaft
Motor pulley
Capstan motor
Push the pulley against here.
