16
VTR 1
Attaching a key label
Attach the key labels to the buttons with the following
procedure.
1
Attach the key-cap puller to the indentations of the
sides of the key cap.
You can easily attach the puller if you press the
buttons on both sides.
2
Remove the key cap by pulling the key-cap puller.
3
Rotate the key-cap puller downwards while
pinching the key-cap, and pull it down to separate
the key cap, and diffuser.
4
Put the key cap, key label with the name written,
and diffuser on the button and replace them as they
were.
As for the key-cap puller (part number: 3-179-054-01),
consult your Sony personnel.
Settings by Using the Buttons
(Setup Function)
With the S-BUS system, the necessary items are
normally set at the control terminal connected to the
primary station. However, the following items may be
set on the unit by turning the power on while holding
down the two or more select buttons, as described
below.
Initializing the settings
While holding down buttons 1 and 2, turn the power
on.
The following items are set to the factory-set
conditions.
1) Status display mode
2) Single-use mode
3) Phantom partial-protect mode
Note
Press buttons until the lamp check on the panel is
completed
Setting single-use mode
While holding down buttons 5 and 8, turn the power
on.
Use this mode when this unit is to be used alone.
Setting prompt lamp-light mode
While holding down buttons 1 and 3, turn the power
on.
When you press a source select button, the lamp of the
pressed button promptly lights.
Setting status display mode
While holding down buttons 1, 2 and 3, turn the power
on.
When you press a source select button, the system
checks that the designated crosspoint has been
switched, then the button lights according to the
crosspoint status.
Preparations
Key-cap puller
Key label
Key cap
Key-cap puller
Diffuser
Attach the key-cap
puller here.
1, 2
3
4
1
2
3
4
9
10 11 12
5
6
7
8
13 14 15 16
1
2
3
4
9
10 11 12
5
6
7
8
13 14 15 16
BKS-R1617
BKS-R1621
Number of the source/destination select buttons
