Sony BKP-7311, Руководство по установке

Страница: 7 / 12

1-3 (E)
BKP-7311 IM
Coaxial cables
150mm
Hole
Coaxial cables
Harness guide
Locking
compound
Nat plate
Harness guide
6. Hook the harness guide onto the rail plate and push it
in the direction of the arrow.
7. Apply locking compound to the thread part, then
tighten screw to install the supplied nut plate.
8. Pass the three coaxial cables through the hole on the
MB-563.
9. Extract the three coaxial cables from the front side
about 150 mm as shown in the figure.
10. Hold the coaxial cables using a supplied harness
clamp.
11. Connect the three coaxial cables to the rear panel.
Connect the flexible card wire removed in step 4 to
CN3.
n
If it is difficult to connect the coaxial cables, remove
the CN-1036 board on the rear panel, and then connect
them.
When installing the board, apply locking compound to
the four screws.
1-3. Installation of BKP-7311
CN-1036 board
Rear panel
MB-563 board
Flexible card wire
PWH3 x 6
B3 x 5
B3
x
5
Cable clamp