2-5 (E)
BDX-N1000
2-3. BDKP-N1003/N1004 Installation
Top panel
B 4
x
6
B 4
x
6
B 3
x
6
B 3
x
6
Rear panel (B)
Supports
Support
CCM-40/40A
board
Support
BNC connectors
PSW 3
x
6
PSW 3
x
6
CN1
Connector
CCM-40/40A
board
IF-694 board
2-3. BDKP-N1003/N1004 Installation
2-3-1. Installation Procedure
1.
Turn off the power of the BDX-N1000 and remove the
power plug from the outlet.
2.
Remove the six screws (B 4
x
6), and remove the top
panel.
3.
Remove the four screws (B 3
x
6), and remove the rear
panel (B).
n
Keep the rear panel (B) and the four screws (B 3
x
6)
that are removed.
n
If the board is changed from BDKP-N1001/N1002 to
BDKP-N1003/N1004, peel the filter and the tape attached
to inside of the rear panel, before performing the step 4.
4.
Insert the BNC connector on the CCM-40/40A board
into the hole of the rear panel.
5.
Align the four screw holes of the board with the four
supports.
6.
Press the connector on the CCM-40/40A board so that
it is connected with the connector CN1 on the IF-694
board.
n
Make sure that the connectors are connected tightly.
7.
Secure the CCM-40/40A board by tightening the four
screws (PSW 3
x
6) supplied with the BDKP-N1003/
N1004.
