Sony AIT-SDX470, Руководство по техническим характеристикам продукции

Страница: 66 / 192

6. ATA Command Specification Set Features
SONY AIT-1 Turbo drive SDX-470V series Ver.1.0 6-24
6.10. Set Features (EFh)
This command is used by the host to establish parameters that affect the execution of certain device features. The
following table defines these features.
Inputs
Register 7 6 5 4 3 2 1 0
Features Subcommand code
Sector Count Subcommand specific
Sector Number Subcommand specific
Cylinder Low Subcommand specific
Cylinder High Subcommand specific
Device/Head 1 na 1 DEV na na na na
Command EFh
Table 6-4: SET FEATURES Register Definitions defines the value of the subcommand in the Feature register.
Some subcommands use other registers, such as the Sector Count register, to pass additional information to the
Sony ATAPI Drive.
Device/Head register -
DEV indicates the selected device.
Normal outputs
See the subcommand descriptions.
Error outputs
Register 7 6 5 4 3 2 1 0
Error na ABRT na
Sector Count na
Sector Number na
Cylinder Low na
Cylinder High na
Device/Head 1 na 1 DEV na
Status BSY DRDY DF DSC DRQ na na CHK
If any subcommand input value is not supported or is invalid, the Sony ATAPI Drive sets the ABRT bit to one.
Error register -
ABRT is set to one if this subcommand is not supported or if value is invalid.
Device/Head register -
DEV indicates the selected device.
Status register -
BSY is cleared to zero when the command is completed.
DRDY is set to one.
DF is set to one if a device fault has occurred.
DSC is set to one.
DRQ is cleared to zero.
CHK is set to one if an Error register bit is set to one.
Prerequisites
DRDY set equal to one.
Description
This command is used by the host to establish parameters that affect the execution of certain device features.
Table 6-4: SET FEATURES Register Definitions defines these features. At power on, or after a hardware reset,
the default setting of the functions specified by the subcommands are vendor specific.