Ultrasonic cleaning process
© Sonoswiss AG
© Sonoswiss AG
BA_Modulrange_SW60/100/200_Sonoswiss_E_06.2012
20
5.5
Ultrasonic cleaning process
Set the switch “on/off” on all devices at “on”. The LED of the
switch flashes blue and each devices is ready to work.
To activate the ultrasound, set the desired cleaning time at the
turning knob „time“. Now, you can select the desired mode of
sweep, degas, sonic
or
boost
and the desired temperature as well
as the ultrasound frequency of 28 or 48 kHz.
After the cleaning process it is necessary to rinse the cleaned
parts to make sure that there are no more residues of chemicals
or particles.
To achieve optimum cleaning results it is important to dry the parts
thoroughly. By setting the required drying temperature (30°C-
130°C) the motor is activated. By inserting the parts into the
drying tank the drying phase is started. Depending on the
application, the drying is completed after 5 min to 10 min.
CAUTION!
In continuous operation the ultrasound can heat up the medium above the set
temperature even without heater is in operation.
To avoid unnecessary heating of the cleaning medium by the ultrasound, especially at
pre-selected low temperatures, please turn on the ultrasound only during the cleaning
phase (apart from degassing and circulation of the medium during the heating).
Switch on the unit(s)
Ultrasonic operation
Rinsing operation
Drying operation
