Sonnen sonnenBatterie ecoLinx 10, Инструкция по установке и эксплуатации, Страница: 46 / 64

38
6. Enter PV system information
Fig. 56 Entering PV system information
▶
Enter the maximum power of your PV system,
as measured in watts.
▶
Press Continue.
7. Enter Generator Autostart information
Fig. 57 Generator Autostart information
The sonnenBatterie ecoLinx can provide a start
signal for a generator to provide power in the
event that the storage system has reached a low
state of charge, the grid is unavailable, and the
PV system is not producing power. When these
criteria are met, the storage system will start the
generator and keep it running until the battery
modules have reached a pre-configured state
of charge, the grid becomes available, or the PV
system begins producing power.
▶
Enter the following information:
• Power: Set this value to 6000 watts for
ecoLinx 10, 12, 14, 16, 18, and 20 units. Set to 0
if you won't be using a generator. This setting
dictates only the power that will be used to
charge the battery modules. Any additional
power the generator produces will go to loads.
• Minimum SOC: Set this to the state of charge
at which the generator should start. Most
users will not want this value to be less than
10 percent. Set to 0 if you won't be using a
generator.
• Maximum SOC: Set this to the state of charge at
which the generator should stop providing power.
Set to 0 if you won't be using a generator.
▶
Press Continue.
8. Enter Time of Use settings
Fig. 58 Time of Use information
Many utility companies are moving to a Time
of Use-based billing scheme, in which electricity
costs more during high-demand time periods. The
storage system can maximize your cost savings by
using your stored battery power during the high-
cost part of the day and recharging from solar and
optionally with electricity purchased from the grid
at the lowest offered rates.
If you enable Time of Use, the storage system
will only discharge during the high-tariff time. The
rest of the day, it will charge its batteries.
▶
Before entering these values, obtain
information from the utility provider about their
time of use scheme, if applicable.
▶
Enter the following information:
• Grid Enable: If you set it to “No,” the storage
unit will not purchase power from the utility to
charge its batteries even during low-tariff times;
instead, it will only charge the batteries from
solar power generation. If you set it to “Yes,”
it will purchase power to charge the batteries
from the grid during low-tariff times only to
ensure the system receives a full charge.
• Peak Hour Start Time: When the high-tariff (or
high-cost) period begins.
• Peak Hour End Time: When the high-tariff
period ends.