A
C
B
D
E
H
F
G
C
E
B
D
J
K
F
July 7, 2020
©2020 SONNEMAN - A Way of Light
6 of 7
Connector (non-Power Feed)
-
Shown with 23CxxE201 (Fig. 10)
1. Drill a 3/4" hole where the Connector (B) is to be installed.
2. Loosen set screws (A) with included Allen key (F) and remove Connector (B) from mounting bracket (C).
3. Insert toggle anchor (D) through hole in wall and tighten screw (E) until it is secured in place.
4. Cap or trim exposed ends of Connector wires and place inside Connector (B).
5. Place connector (B) on mounting bracket (C) and secure by tightening set screws (A) with included Allen key.
Connector Installation (cont.)
Power Feed Connector with Remote Driver
-
Shown with 23CxxE201 (Fig. 8-9)
1. Shut off power to the branch circuit conductors.
2. The LED driver (A) must be installed in a remote and accessible location near the fixture in accordance with local
electrical code (Fig. 9). Make appropriate electrical connections using wire nuts:
a. Connect the LED driver's (A) live wire to the live branch circuit conductor.
b. Connect the LED driver’s neutral wire to the neutral branch circuit conductor.
c. Connect the LED driver’s positive (+) output wire to the required length of red wire (not included) to reach the
Connector (B).
d. Connect the LED Driver's negative (-) output wire to the required length of black wire (not included) to reach the
Connector.
3. Drill a 3/4" hole (J) in the wall where the Connector (B) is to be installed.
4. Using included Allen key (K), loosen set screws (H) and remove Connector (B) from mounting bracket (C).
5. Pull low voltage wires (F) through off-center hole (G) in mounting bracket (C).
6. Make appropriate electrical connections using wire nuts:
a. Connect the positive (red) low voltage wire to the Connector red wire.
b. Connect the negative (black) low voltage wire to the Connector black wire.
c. Carefully place connections inside Connector (C).
7. Insert toggle anchor (D) through hole in wall (J) and tighten screw (E) until it is secured in place, making sure not to
pinch the connector wires.
8. Place connector (B) on mounting bracket (C) and secure by tightening set screws (H) with included Allen key.
A
Fig. 9
Fig. 8
Fig. 10
Содержание purolinear 360
Страница 1: ...purolinear 360 assembly instructions...
