SONIQ qv220lti, Инструкция по эксплуатации

Страница: 12 / 36

- 12 -
USING THE REMOTE CONTROL
When using the remote control, aim it at remote sensor on the unit. If there is an object between the
remote control and the signal remote sensor on the unit, the unit may no operate.
• Point the remote control at the REMOTE SENSOR located on the unit.
• When using this unit in a very brightly lit area, the infrared REMOTE CONTROL SENSOR may
not work properly.
• The recommended effective distance for using the remote control is about 16 feet (5 metres).
TO CHANGE THE REMOTE CONTROL BATTERY
BATTERY REPLACEMENT
You will need to install the supplied batteries into the remote control to make it operate following the
instruction below.
When the batteries become weak, the operating distance of the remote control will be greatly reduced
and you will need to replace the batteries.
Notes on Using Batteries:
The use of the wrong type of batteries may cause chemical leaks and/or explosion. Please note the
following:
• Always ensure that the batteries are inserted with the positive and negative terminals in the correct
direction as shown in the battery compartment.
• Different types of batteries have different characteristics. Do not mix different types.
• Do not mix old and new batteries. Mixing old and new batteries will shorten battery life and/or cause
chemical leaks from the old batteries.
• When batteries fail to function, replace them immediately.
• Chemicals which leak from batteries may cause skin irritation. If any chemical matter seeps out of
the batteries, wipe it up immediately using a dry cloth.
• Due to varying storage conditions, the battery lift for the batteries included with your unit may be
shorten. If the remote control is not used for a long period of time, remove the batteries.
• The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
CAUTION:
Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent
type.
Getting Started
1. Open the lid of the remote control battery
compartment.
2. Insert two size-AAA batteries.
Ensure that the batteries are inserted with the
positive and negative terminals in the correct
direction corresponding to the (+) and (-) marks
in the battery compartment.