Sonifex SOVEREIGN MX-14S, Руководство пользователя, Страница: 47 / 65

?PVT &! <PbcTa >dc_dc <^]Xc^a <^Sd[T
C_fUbUYW^ EcUbc 7eYTU
& >dc_dcb
& <PbcTa >dc_dc 5PSTab >_cX^]P[
The 100mm long throw ALPS VCA carbon fader provides a unity gain ( 0dB )
when fully open. The scale shows the attenuation. These faders are optional and are not supplied as
standard. They should be added in any situation where the levels of the master outputs, A and B, may
need to be altered, for example in a production studio. For on-air use, they will generally not be
needed, because the output level for the A and B outputs should be fixed. The master outputs are the
XLR connectors on the rear of the module.
& ! <^]^ 5TTS >dc_dc BT[TRcX^]
The mono feed is usually used as the main output if you
are broadcasting in mono, or have an AM service. The output connections
are found on pins 6 and 13 of the 15 pin D-Type socket on the rear panel.
Either output A, output B, or both, can be assigned to the mono output by
selecting the appropriate buttons. The red LED illuminates in the button
when the output is selected.
& " 30 >dc_dcb
Every Sovereign mixer is fitted as standard with a Distribution Amplifier in the
output section. This provides four balanced stereo outputs which are normally used to feed the inputs
of recording units, to record audio from the desk. The configuration of each DA output is managed by
the use of jumpers on the two output PCB’s. Jumpers J3 - J6 can be used to set the left and right DA
outputs 1 - 4 independently to either output A or B. This is covered in Section 7.6.
&! <TcTa 5^[[^f BT[TRcX^]
The meters are housed in the meterbridge section, to the right of the MX10 and in
the middle of the MX14S. The display on the meters can be altered to show
any combination of the A output, the B output, or whatever is selected on
the Control Room section of this module. When a red LED is illuminated,
it indicates that that signal is routed to the meters. For example, if CR
MON is selected for the meters, and the CONTROL ROOM has EXT 1
selected, then the meters will display the EXT 1 signal.
The CR MON selection will also display the PFL signal
on the meters, if either AUTO PFL, or SPLIT PFL are selected. In the case
of the SPLIT PFL, the input ( A, B, EXT 1 or EXT 2 ) is mono summed to
the left meter while the PFL is summed on the right meter.