Sonifex AVN-TB6, Руководство пользователя

Страница: 20 / 64

10
4 Rear Panel Connections
Headset Connector (AVN-TB6 only)
This 5 pin XLR socket is the connection for the headset. The connections are
as follows:
Pin 1: Microphone Non-Phase
Pin 2: Microphone Phase
Pin 3: Ground
Pin 4: Headphone Left
Pin 5: Headphone Right
Phantom power can be supplied if required. To change the headset settings,
see the Audio - Microphone Settings web page on page 33 for details.
GPI/O
This 15 pin ‘D’ type socket provides 10 configurable general purpose inputs
or outputs and a voltage free switching relay contact. The connections are
as follows:
Pin 1 GPIO Port 1
Pin 2 GPIO Port 2
Pin 3 GPIO Port 3
Pin 4 GPIO Port 4
Pin 5 GPIO Port 5
Pin 6 Relay – Normally Open Contact
Pin 7 Relay – Normally Closed Contact
Pin 8 Relay – Common
Pin 9 GPIO Port 6
Pin 10 GPIO Port 7
Pin 11 GPIO Port 8
Pin 12 GPIO Port 9
Pin 13 GPIO Port 10
Pin 14 Fused (200mA) +12VDC Supply
Pin 15 Ground
GPIO ports configured as an output are open collector type. GPIO inputs are
active low. See the GPIO Settings web page on page 37 for details on how
to configure the GPIO and relay settings.
Ethernet 1GB & AoIP 1GB Network
Interfaces
These RJ45 connectors are the gigabit network ports. The upper connector
is the configuration and control port and the lower connector is the audio
over IP (AoIP) port.
AoIP SFP Interface
This SFP (small form-factor pluggable) connector allows an alternative
interface type to be used for the AoIP port, for example fibre. If a SFP
interface is used, the AoIP network port cannot be used at the same time.
12V DC Input
This 4 pin connector allows an ex12V power supply to be used to
power the unit. When looking at the rear of the unit, the pin locations and
connections are as follows:
Location Connection
Pin 1 Upper Left +12V DC
Pin 2 Upper Right +12V DC
Pin 3 Lower Left 0V
Pin 4 Lower Right 0V
Both the 12V DC input and the mains AC input can be connected at the
same time.