SonicWALL NSA E7500, Руководство по началу работы

Страница: 34 / 43

SonicWALL NSA E7500 Getting Started Guide Page 33
EFT DRAFT
Appendix C: Safety Instructions and Regulatory
Information
Regulatory Model/Type Product Name
1RK11-04e E7500
Rack Mounting the SonicWALL
The above SonicWALL appliances are designed to be mounted in a
standard 19-inch rack mount cabinet. The following conditions are
required for proper installation:
• Use the mounting hardware recommended by the rack manufacturer
and ensure that the rack is adequate for the application.
• Four mounting screws, compatible with the rack design, must be
used and hand tightened to ensure secure installation. Choose a
mounting location where all four mounting holes line up with those of
the mounting bars of the 19-inch rack mount cabinet.
• Mount in a location away from direct sunlight and sources of heat. A
maximum ambient temperature of 104º F (40º C) is recommended.
• Route cables away from power lines, fluorescent lighting fixtures,
and sources of noise such as radios, transmitters and broadband
amplifiers.
• The included power cord is intended for use in North America only.
For European Union (EU) customers, a power cord is not included.
• Ensure that no water or excessive moisture can enter the unit.
• Allow unrestricted airflow around the unit and through the vents on
the side of the unit. A minimum of 1 inch (25.44mm) clearance is
recommended.
• Mount the SonicWALL appliances evenly in the rack in order to
prevent a hazardous condition caused by uneven mechanical
loading.
• Consideration must be given to the connection of the equipment to
the supply circuit and the effect of overloading the circuits has
minimal impact on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings must be
used when addressing this concern.
• Reliable grounding of rack-mounted equipment must be maintained.
Particular attention must be given to power supply connections other
than direct connections to the branch circuits such as power strips.
Lithium Battery
Warning
The Lithium Battery used in
the SonicWALL Internet
security appliance may not be
replaced by the user. The
SonicWALL must be returned
to a SonicWALL authorized
service center for
replacement with the same or
equivalent type
recommended by the
manufacturer. If, for any
reason, the battery or
SonicWALL Internet security
appliance
must be disposed of, do so
following the battery
manufacturer's instructions.
Cable Connections
All Ethernet and RS232
(Console) cables are
designed for intra-building
connection to
other equipment. Do not
connect these ports directly to
communication wiring or other
wiring that exits the building
where the SonicWALL is
located.